Hyundai Accent: Removal
| 1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 2. |
Turn the steering wheel so that the front wheels can face straight
ahead.
|
| 3. |
Remove the driver airbag module mounting bolts (2EA).
|
| 4. |
Remove the wiring fixing clip (C), and then release the connector
locking pin to disconnect the driver airbag module connector (B).
|
| 5. |
Remove the steering wheel and steering wheel column shroud.
(Refer to the Steering System group - "Steering Column and Shaft")
|
| 6. |
Disconnect the clock spring connector, then remove the clock spring.
|
Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
See also:
Localised Assistance Call
If the vehicle breaks down, press button 2
for more than 2 seconds to request assistance
(confirmed by a voice message*).
Pressing again immediately cancels the
request.
Privacy mode allows ...
Seat Heater. Repair procedures
Inspection
Driver seat and Passenger seat
1.
Check for continuity and measure the resistance between terminals.
[Cushion]
...
Engine number
The engine number is stamped on the engine block as shown in the drawing. ...
Hyundai Accent Manuals
В© 2011-2025 Copyright www.hamanual.com