Hyundai Accent: Anchor Pretensioner (APT). Description and Operation
Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / Seat Belt Pretensioner / Anchor Pretensioner (APT). Description and Operation
Description
Front anchor pretensioner operates as well as Belt Pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on driver seat and it is an equipment to make up for the existing
short stroke. Front anchor pretensioner is supported by two cables and it is
an auxiliary equipment to prevent a driver and passenger from breaking away
doubly as seat belt is being pulled toward anchor side after a collision.
Never measure resistance of Anchor Pretensioner directly, Current
of measuring device may cause unexpected airbag deploy.
|
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes.
...
See also:
26 Brake Control Solenoid Valve(26/B_VFS). Specifications
Specifications
Direct control VFS[26/B]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
9.81 ~ 500.14
(0.1 ~ 5.5, 1.42 ~ 7.82)
...
3. Exhaust emission control system
The Exhaust Emission Control System is a highly effective system which controls
exhaust emissions while maintaining good vehicle performance.
Vehicle modifications
This vehicle should not be mo ...
Inspection
1.
Check the signal waveform of the CMPS and CKPS using
the GDS.
Specification:
Refer to “Wave Form”
...
Hyundai Accent Manuals
© 2011-2025 Copyright www.hamanual.com