Inspection
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
[Auto Down]
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
3. |
Disconnect the 8P connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
Canister Close Valve (CCV). Specifications
Specification
Item
Specification
Coil Resistance (Ω)
19.8 ~ 20.8 [20°C(68°F)
...
Rear Body ( 5Door )
Side outer panel rear corner
Tail gate hinge mounting hole (Ø14)
Tail gate hinge mounting hole ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Description and Operation
Description
Overdrive clutch control solenoid valve(OD/C_VFS) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the overdrive ...