Hyundai Accent Manuals

Hyundai Accent: Removal - Front Wiper Motor. Repair 
procedures - Windshield Wiper/Washer - Body Electrical SystemHyundai Accent: Removal

1.
Loosen the windshield wiper arm nut (A) after removing a wiper cap (B).

2.
Remove the windshield wiper arm and blade.
3.
If necessary, release the wiper blade fixing clip by pulling up and remove the wiper blade from the inside radius of wiper arm.

4.
Disconnect the washer hose (A) connected to cowl top cover.

5.
Remove the weather strip and the cowl top cover (A) after removing rivets.

6.
Disconnect the wiper motor connector (A) from the wiper motor & linkage assembly.

7.
Remove the windshield wiper motor and linkage assembly (A) after removing 2 bolts.

8.
Hold the wiper motor crank arm and remove the upper linkage (A) from the wiper motor crank arm.

Before removing the wiper motor and linkage assembly, make sure that the linkage is stopped at auto stop position.
To install the wiper motor crank arm exactly, check that the linkage is aligned with the crank arm in straight line and the angle of each linkages.
Be careful not to bend the linkage.
9.
Loosen 3 bolts and remove the wiper motor(A) from the wiper motor crank arm.


Front Wiper Motor. Repair procedures
...

Installation
1. Install the wiper motor. 2. Install the crank arm. 3. Install the lower and upper linkage to the wiper motor ...

See also:

Replacement
ATF of 6 speed automatic transaxle doesn’t need to be replaced. If the vehicle is used severely in business or personal use, ...

To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is ...

Replacement
Rear Brake Pads 1. Loosen the guide rod bolt (B) and then remove the rear caliper body (A). Tightening torque: 21.6 ~ 31 ...

Hyundai Accent Manuals


В© 2011-2024 Copyright www.hamanual.com