LOCK
The steering wheel locks to protect against theft (if equipped). The ignition key can be removed only in the LOCK position.
When turning the ignition switch to the LOCK position, push the key inward at the ACC position and turn the key toward the LOCK position.
ACC (Accessory)
The steering wheel is unlocked (if equipped) and electrical accessories are operative.
NOTICE
If difficulty is experienced in turning the ignition switch to the ACC position, turn the key while turning the steering wheel right and left to release the tension.
ON
The warning lights can be checked before the engine is started. This is the normal running position after the engine is started.
To prevent discharge of the battery, do not leave ignition switch on for long time while engine is not running.
START
Turn the ignition switch to the START position to start the engine. The engine will crank until you release the key; then it returns to the ON position.The brake warning lamp can be checked in this position.
WARNING - Ignition switch
ESC Control Module. Components and Components Location
Components
1. Front - left tube
2. Rear - right tube
3. Rear - left tube
4. Front - right tube
5. MC2
6. MC1
7. ABS control module (HECU)
8. Damper
...
Interior Trim. Repair procedures
Replacement
Door Scuff Trim Replacement
[Sedan]
•
Put on gloves to protect your ...
Antenna Coil. Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing
3 sc ...