Hyundai Accent: Inspection
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the HO2S connector.
|
| 3. |
Measure resistance between the HO2S terminals 4 and
5 [B1/S1].
|
| 4. |
Measure resistance between the HO2S terminals 3 and
4 [B1/S2].
|
| 5. |
Check that the resistance is within the specification.
|
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the connector (A), and then remove the
se ...
See also:
Repair procedures
Troubleshooting
Starter Circuit
The battery must be in good condition and fully charged.
1.
...
Heated Oxygen Sensor (HO2S). Troubleshooting
Signal Waveform
...
Automatic illumination of headlamps
When the ring is at the “AUTO" position and
a low level of ambient light is detected by the
rain/sunshine sensor, the number plate lamps,
sidelamps and dipped beam headlamps are
switched on auto ...
Hyundai Accent Manuals
© 2011-2025 Copyright www.hamanual.com