Hyundai Accent: Opening the hood
1.Pull the release lever to unlatch the hood. The hood should pop open slightly.
WARNING
Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P(Park) position for automatic transaxle and to the 1st(First) gear or R(Reverse) for manual transaxle, and setting the parking brake.
2. Go to the front of the vehicle, raise the hood slightly, pull the secondary latch (1) inside of the hood center and lift the hood (2).
3.Pull out the support rod from the engine room.
4.Hold the hood open with the support rod.
WARNING - Hot parts
Grasp the support rod in the area wrapped in rubber. The rubber will help prevent you from being burned by hot metal when the engine is hot.
Hood
...
Closing the hood
1. Before closing the hood, check the following:
All filler caps in engine compartment must be correctly installed.
Gloves, rags or any other combustible material must be removed from the
eng ...
See also:
Measuring Body Dimensions
1.
Basically, all measurements in this manual are taken
with a tracking gauge.
2.
When a measuring tape is used, check to be sure there
...
Seat belt restraint system
WARNING
For maximum restraint system protection, the seat belts must always
be used whenever the car is moving.
Seat belts are most effective when seatbacks are in the upright position.
Ch ...
Immobilizer Control Unit. Repair
procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash ...
Hyundai Accent Manuals
