Hyundai Accent: Check Fuses

A blade type fuse test taps provided to allow checking the fuse itself without removing if from the fuse box. The fuse is good if the test lamp lights up when one lead is connected to the test taps (one at a time) and the other lead is grounded. (Turn the ignition switch so that the fuse circuit becomes operative)

Checking Cables And Wires

1. Check the terminal for tightness. 2. Check terminals and wires for corrosion from battery electrolyte, etc. 3. ...

Servicing The Electrical System

1. Prior to servicing the electrical system, be sure to turn off the ignition switch and disconnect the battery ground cable. ...

See also:

Replacement
Repair tire after using the Tire Mobility Kit (TMK) When the TPMS warning lamp OFF 1. Remove the TMK repaired tire, wheel and TPMS sensor. (Refer ...

Installation
1. Installation is reverse of removal. Fuel pump plate cover installation bolt : 1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2 ...

Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to desired position to operate the rear wiper and washer. - Spraying washer ...