Hyundai Accent: Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed of 12 mph (20 km/h).
While driving, if you experience any unusual vibration, ride disturbance or noise, reduce your speed and drive with caution until you can safely pull off of the side of the road.
Call for road side service or towing.
When you use the Tire Mobility Kit, the tire pressure sensors and wheel may be damaged by sealant, remove the sealant stained with tire pressure sensors and wheel and inspect in authorized dealer.
Using the Tire Mobility Kit
1. Detach the speed restriction label (0) from the sealant bottle (1), and place
it in a highly visible place inside the vehicle such as on the steering wheel to
remind the driver not to drive too ...
Checking the tire inflation pressure
1.After driving approximately 4~6miles (7~10km or about 10min), stop at a safety
location.
2.Connect connection hose (9) of the compressor directly to the tire valve.
3.Plug the compressor power c ...
See also:
2. Evaporative emission control (including ORVR: Onboard Refueling Vapor Recovery)
system
The Evaporative Emission Control System is designed to prevent fuel vapors from
escaping into the atmosphere. (The ORVR system is designed to allow the vapors from
the fuel tank to be loaded into ...
Interior Trim. Components and Components
Location
Components
1. Front pillar trim
2. Center pillar lower trim
3. Center pillar upper trim
4. Rear pillar trim [4 Door]
5. Rear wheelhousing trim
6. Front door scuf ...
Transaxle Oil Temperature Sensor. Specifications
Specifications
▷ Type: Negative Thermal Coefficient Type
Temp.[(°C)°F]
Resistance (kΩ)
(-40)-40
48.1
(-20)-4.0 ...
Hyundai Accent Manuals
