Loosen the radiator upper cover mounting bolts and clips.
Remove the mounting clips.
After loosening the front bumper side’s mounting screw, then disconnect the side’s.
Push the lock pin, disconnect the fog lamp connector (A).
Remove the front bumper.
Installation is the reverse of removal.
Aux, USB and iPod® port
If your vehicle has an aux and/or USB(universal serial bus) port or iPod® port, you can use an aux port to connect audio devices and a USB port to plug in a USB, or use the HYUNDAI accessory iPo ...
To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is ...
Rear combination light bulb replacement (5 Door)
(1) Tail light (2) Rear turn signal light (3) Back-up light (4) Stop and tail light (5) Side marker 1. Open the tailgate. 2. Loosen the light assembly retaining screws with a cross-tip screw ...