Hyundai Accent: Inspection

Lighting Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.

Lighting switch

HS : Head lamp switch(Short inside)

Dimmer And Passing Switch

HU : Head lamp high beam

HL : Head lamp low beam

HF : Head lamp passing switch

HS : Head lamp switch(Short inside)

Turn Signal Switch

Front Fog Lamp Switch

Wiper And Washer Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.

Wiper Switch (Intermittent)

INT 1 : Intermittent switch 1(Short inside)

INT 2 : Intermittent switch 2(Short inside)

B1 : B1(Short inside)

Wiper Switch

Washer Switch

Repair procedures

...

Removal

Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper (A) and lower (B) shrouds aft ...

See also:

Tire sidewall labeling
This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be use ...

Side Airbag (SAB) Module. Components and Components Location
Components ...

Room lamp
ON (1): In the ON position, the light stays on at all times. DOOR (2) : In the DOOR position, the light comes on when any door is opened regardless of the ignition switch position. When doors ...