Hyundai Accent Manuals

Hyundai Accent: Inspection - ETC (Electronic Throttle Control) System. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / ETC (Electronic Throttle Control) System. Repair procedures / Inspection

Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle angle(°)
 Output Voltage (V)
TPS1
 TPS2
C.T
 0.5
 4.5
W.O.T
 4.41
 0.59

ETC Motor
1.
Turn the ignition switch OFF.
2.
Disconnect the ETC module connector.
3.
Measure resistance between the ETC module terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”

ETC (Electronic Throttle Control) System. Repair procedures
...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer ...

See also:

SRSCM Connector terminal
Pin Function (Connector A) Pin Function (Connector B) 1 Ignition 1 Seat belt pretensioner [Drive ...

Relay Box (Engine Compartment). Repair procedures
Inspection Power Relay Test (Type A) - Do not use pliers. - ...

Installation
1. Installation is the reverse of removal. Coat the clutch clevis push ro ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com