Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS). Repair procedures / Inspection

1.	Turn the ignition switch OFF.

2.	Remove the ECTS (Refer to "Removal").

3.	After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.

4.

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Engine Coolant Temperature Sensor (ECTS). Repair procedures

...

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the engine coolant temperature sensor con ...

See also:

Troubleshooting
Troubleshooting Starting System Symptom Suspect area Remedy Engine will not crank Battery charge low Charge or replace batt ...

Installation
1. Install the oil pan. (1) Using a razor blade and gasket scraper, remove all the old packing material from the gasket surfaces. ...

Components and Components Location
Components Location 1. Sub frame 2. Drive shaft 3. Lower arm 4. Strut assembly 5. Steering gearbox 6. Stabilizer bar ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com