Hyundai Accent: Inspection
| 1. |
Check signal waveform of CKPS and CMPS using a GDS.
|
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the crankshaft position sensor connector
...
See also:
Inspection
1.
Check the driveshaft boots for damage and deterioration.
2.
Check the driveshaft spline for wear or damage.
3.
...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
...
Inspection
1.
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring
of thinning. If the quality is visibly poor, replace the oil.
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com