Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF). Repair procedures / Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the oil temperature sensor connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

SS-B Solenoid Valve(ON/OFF). Repair procedures

...

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

See also:

Thermostat. Components and Components Location
Components 1. Water inlet fitting 2. Thermostat 3. Heater pipe 4. Bypass hose 5. Water temp control assembly 6. Water temperature sensor 7. Gasket ...

Removal
1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 2. Remove the rear sea ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com