Hyundai Accent: Installation| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
| 3. |
Connect the clock spring harness connector to the clock spring.
|
| 4. |
Install the steering column shroud.
|
| 5. |
Set the center position by setting the marks between the clock
spring and the cover into line. Make an array the mark (▶◀) by turning
the clock spring clockwise to the stop and then 2.0 revolutions counterclockwise.
|
| 6. |
Install the steering wheel.
(Refer to the Steering System group - "Steering Column and Shaft")
|
| 7. |
Connect the driver airbag (DAB) module connector, and then install
the driver airbag (DAB) module on the steering wheel.
|
| 8. |
Secure driver airbag (DAB) with the new mounting bolts.
|
| 9. |
Connect the battery negative cable.
|
| 10. |
After installing the airbag, confirm proper system operation:
|
Inspection
Passenger Airbag (PAB) Module. Description
and OperationGeneral Information
The Micro 570 Analyzer (Canada only)
The Micro 570 Analyzer provides the ability to test the charging
and starting systems, including the battery, starter and alternator.
...
Using a child restraint system
For small children and babies, the use of a child seat or infant seat is required.
This child seat or infant seat should be of appropriate size for the child and should
be installed in accordanc ...
SRS Care
The SRS is virtually maintenance-free and so there are no parts you can safely
service by yourself. If the SRS air bag warning light ""
does not illuminate, when you turn the ignition on ...