Hyundai Accent: Installation
Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
|
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes.
|
| 3. |
Install the new seat back assembly.
(Refer to the Body group - "Seat")
|
| 4. |
Install the front seat assembly.
(Refer to the Body group - "Seat")
|
| 5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfering with other parts.
|
| 6. |
Reconnect the battery negative cable.
|
| 7. |
After installing the side airbag (SAB), confirm proper system
operation:
|
Removal
Curtain Airbag (CAB) Module. Description
and OperationInspection
1.
Check the driveshaft boots for damage and deterioration.
2.
Check the driveshaft spline for wear or damage.
3.
...
Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks or roots
of trees. Become familiar with the off-road conditions where you are going to drive
before you begin driving. ...
Removal
Passenger Compartment Junction Box
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to t ...