Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Multifunction switch / Repair procedures / Installation

Multifunction Switch

1.	Install the multifunction switch.

2.	Install the clock spring.

3.	Install the steering column upper and lower shrouds.

4.

Install the steering wheel.

Make sure the multifunction switch connectors are plugged in properly.

Flasher Unit

1.	Install the flasher unit.

2.

Fasten the bolt and connect the flasher unit connector.

Make sure the flasher unit connector is plugged in properly.

Removal

Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper (A) and lower (B) shrouds aft ...

Horn

...

See also:

How to use this manual
We want to help you get the greatest possible driving experience from your vehicle. Your Owner’s Manual can assist you in many ways. We strongly recommend that you read the entire manual. In ord ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the connector (A), and then remove the se ...

Rear Door. Components and Components Location
Components 1. Rear door trim 2. Rear door seal 3. Rear door panel 4. Rear door delta inner cover 5. Rear door channel 6. Rear door belt inside weatherstrip 7. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com