Hyundai Accent Manuals

Hyundai Accent: Installation - Engine Coolant Temperature Sensor (ECTS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply the engine coolant to the O-ring.
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Engine Coolant Temperature Sensor installation :
29.4 ~ 39.2 N.m (3.0 ~ 4.0 kgf.m, 21.7 ~ 28.9 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the engine coolant temperature sensor con ...

Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...

See also:

Replacement
1. Disconnect the back up lamp switch connector (A). 2. Remove the back up lamp switch (A). 3. ...

Installation
Side Impact Sensor • Do not turn the ignition switch ON and do not connect the battery c ...

Removal
1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com