Hyundai Accent Manuals

Hyundai Accent: Installation - Crankshaft Position Sensor (CKPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply the engine oil to the O-ring.
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Crankshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector ...

Camshaft Position Sensor (CMPS). Description and Operation
Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects t ...

See also:

Installation
Installation is the reverse of removal. Canister installation bolt/nut: 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft) ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Thermostat. Components and Components Location
Components 1. Water inlet fitting 2. Thermostat 3. Heater pipe 4. Bypass hose 5. Water temp control assembly 6. Water temperature sensor 7. Gasket ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com