Hyundai Accent Manuals

Hyundai Accent: Installation - Knock Sensor (KS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Knock Sensor (KS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And E ...

Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

See also:

Crash Pad. Components and Components Location
Components 1. Main crash pad assembly 2. Side airvent duct [RH] 3. Side airvent duct [LH] 4. Cluster assembly 5. Cluster facia panel 6. Heater control unit 7. ...

Inspection
Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of ...

Components and Components Location
Components Location 1. Torsion beam axle 2. Shock absorber 3. Coil spring assembly 4. Rear disc ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com