When heavy rear components such as suspension, fuel
tank, spare tire, tailgate and trunk lid are to be removed, place additional
weight in the luggage area before hoisting. When substantial weight
is removed from the rear of the vehicle, the center of gravity may change
and can cause the vehicle to tip forward on the hoist.
|
|
1. |
Place the lift blocks under the support points as
shown in the illustration.
|
2. |
Raise the hoist a few inches (centimeters) and rock
the vehicle to be sure it is firmly supported.
|
3. |
Raise the hoist to full height to inspect the lift
points for secure support.
|
To increase cruise control set speed
Follow either of these procedures:
Push the RES+ switch and hold it. Your vehicle will accelerate. Release
the switch at the speed you want.
Push the RES+ switch and release it immediately. ...
Capacity/weight
...
Floor mat anchor
When using a floor mat on the front floor carpet, make sure it attaches to the
floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.
WARNING
The floor mat must be ...