Hyundai Accent: Lighting control
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of the following positions:
(1) OFF position
(2) Parking light position
(3) Headlight position
Parking light position (
)
When the light switch is in the parking light position, the tail, position and license plate lights will turn on and the tail light indicator will turn on.
Headlight position (
)
When the light switch is in the headlight position the head, tail, license and instrument panel lights will turn on.
NOTICE
The ignition switch must be in the ON position to turn on the headlights.
Headlamp delay
If you turn the ignition switch to the ACC or OFF position with the headlights
ON, the headlights remain on for about 20 minutes. However, if the driver’s door
is opened and closed, the headligh ...
High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back
for low beams.
The high beam indicator will light when the headlight high beams are switched
on.
To prevent the ...
See also:
Tire terminology and definitions
Air Pressure: The amount of air inside the tire pressing outward on the
tire. Air pressure is expressed in pounds per square inch (psi) or kilopascal (kPa).
Accessory Weight: This means the combine ...
How vehicle audio works
FM radio reception
AM and FM radio signals are broadcast from transmitter towers located around
your city. They are intercepted by the radio antenna on your vehicle. This signal
is then receive ...
Rear Seat Belt. Repair procedures
Replacement
Rear Seat Belt Replacement
[Sedan]
•
When installing the belt, make s ...
Hyundai Accent Manuals
