Hyundai Accent Manuals

Hyundai Accent: Manual transaxle operation - Manual transaxle - Driving your vehicleHyundai Accent: Manual transaxle operation

The shift lever can

be moved into any of the forward gears without pressing the button (1).The shift lever can be moved into any of the forward gears without pressing the button (1).

button (1) when moving the shift lever into reverse.You should press the button (1) when moving the shift lever into reverse.

The manual transaxle has 6 forward gears.

This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized in all forward gears so shifting to either a higher or a lower gear is easily accomplished.

To shift gears, press the clutch pedal down fully, select the desired gear with the gearshift lever, and release the clutch pedal slowly.

If your vehicle is equipped with an ignition lock switch, the engine will not start when starting the engine without depressing the clutch pedal.

The shift lever must be returned to the neutral position before shifting into R (Reverse). The button (1) located at the bottom front of the shift knob must be pressed and held in while moving the shift lever to the R (Reverse) position.

Make sure the vehicle is completely stopped before shifting into R (Reverse). Never operate the engine with the tachometer (rpm) in the red zone.

CAUTION

CAUTION

Before leaving the driver’s seat, always set the parking brake fully and WARNING

Before leaving the driver’s seat, always set the parking brake fully and shut the engine off. Then make sure the transaxle is shifted into 1st gear when the vehicle is parked on a level or uphill grade, and shifted into R (Reverse) on a downhill grade. Unexpected and sudden vehicle movement can occur if these precautions are not followed in the order identified.

Using the clutch

The clutch should be depressed all the way to the floor before shifting, then released slowly. The clutch pedal should always be fully released while driving. Do not rest your foot on the clutch pedal while driving. This can cause unnecessary wear. Do not partially engage the clutch to hold the vehicle on an incline. This causes unnecessary wear. Use the foot brake or parking brake to hold the vehicle on an incline. Do not operate the clutch pedal rapidly and repeatedly.

Downshifting

It is important to downshift when you must slow down in heavy traffic or while driving up or down steep hills. Downshifting reduces the chance of stalling and gives better acceleration. When the vehicle is traveling down steep hills, downshifting helps maintain safe speed and prolongs brake life.

Manual transaxle
...

Good driving practices
Never take the vehicle out of gear and coast down a hill. This is extremely hazardous. Always leave the vehicle in gear. Do not "ride" the brakes. This can cause them to overheat and ...

See also:

Replacement
Front Brake Pads 1. Remove the brake hose mounting bracket bolt (A). Tightening torque: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.7 ...

Teaching Procedures
1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM (ECM) or when providing additional keys to the vehicle owner. Th ...

Interior Trim. Components and Components Location
Components 1. Front pillar trim 2. Center pillar lower trim 3. Center pillar upper trim 4. Rear pillar trim [4 Door] 5. Rear wheelhousing trim 6. Front door scuf ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com