Hyundai Accent: Measurement Point

Measurements should be taken at the center of the hole.

Measuring Actual Dimensions

1. These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurem ...

Checking Cables And Wires

1. Check the terminal for tightness. 2. Check terminals and wires for corrosion from battery electrolyte, etc. 3. ...

See also:

Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels al ...

Variable Intake Solenoid (VIS) Valve. Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

Removal
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury ...