Hyundai Accent Manuals

Hyundai Accent: Oil And Filter Replacement - Engine Oil. Repair procedures 
- Revised - Lubrication System - Engine Mechanical SystemHyundai Accent: Oil And Filter Replacement

•
Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
•
Exercise caution in order to minimize the length and frequency of contact of your skin to used oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use water-less hand cleaner, to remove any used engine oil. Do not use gasoline, thinners, or solvents.
•
In order to preserve the environment, used oil and used oil filter must be disposed of only at designated disposal sites.
1.
Drain the engine oil.
(1)
Remove the oil filler cap.
(2)
Remove the oil drain plug, and drain the oil into a container.
2.
Replace the oil filter.
(1)
Remove the oil filter.
(2)
Check and clean the oil filter installation surface.
(3)
Check the part number of the new oil filter is as same as old one.
(4)
Apply clean engine oil to the gasket of a new oil filter.
(5)
Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.
(6)
Tighten it with the torque below.

Tightening torque :
11.8 ~ 15.7N.m (1.2 ~ 1.6kgf.m, 8.7 ~ 11.6lb-ft)

3.
Refill with engine oil.
(1)
Clean and install the oil drain plug with a new gasket.

Tightening torque :
34.3 ~ 44.1N.m (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)

(2)
Fill with fresh engine oil.

Capacity
Total : 4.0L (4.22US qt, 3.51lmp qt)
Oil pan : 3.3L (3.48US qt, 2.90lmp qt)
Drain and refill in cluding oil filter :
3.6L (3.80US qt, 3.16lmp qt)

(3)
Install the oil filler cap.
4.
Start engine and check for oil leaks.
5.
Recheck the engine oil level.

Oil And Filter Replacement
• Prolonged and repeated contact with mineral oil will result in the removal of natural fats ...

Inspection
1. Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. ...

See also:

Back-up Lamp Switch. Specifications
Specifications 1. Working voltage: DC 10~15V 2. Operating force: 3.0kg Max. 3. Voltage drop: - 0.4V ...

Owner maintenance precautions
Improper or incomplete service may result in problems. This section gives instructions only for the maintenance items that are easy to perform. As explained earlier in this section, several procedu ...

Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com