Inspection
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Using a screwdriver or remover, remove the center fascia garnish
(A).
|
3. |
Disconnect defroster switch connector (A).
|
4. |
Using an ohmmeter, inspect the continuity between the terminals.
|
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts' Resistance
The ...
Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Components Operations
PCM (Power Train Control Module)
1.
The PCM (ECM) (A) carries out a check of the ignition key using
a special encryption algorithm, which is programmed into the transp ...