Hyundai Accent Manuals

Hyundai Accent: Removal - Passive Occupant Detection System (PODS-F). Repair procedures - SRSCM - Restraint (Advanced) - Hyundai Accent 2010-2019 Service ManualHyundai Accent: Removal

PODS-F ECU
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front passenger seat assembly.
(Refer to the Body group - "Seat")
3.
Remove the seat cushion cover assembly.
(Refer to the Body group - "Seat")
4.
Remove the seat track assembly.
(Refer to the Body group - "Seat")
PODS-F Mat
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front passenger seat assembly.
(Refer to the Body group - "Seat")
3.
Remove the seat cushion assembly.
(Refer to the Body group - "Seat")

Passive Occupant Detection System (PODS-F). Repair procedures
...

Installation
PODS-F ECU 1. Install the PODS-F ECU equipped seat track assembly. (Refer to the Body group - "Seat") 2. Install the ...

See also:

General
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...

Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side ...

Categories

Hyundai Accent Manuals

© 2011-2019 Copyright www.hamanual.com