|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Using a screwdriver or remover, remove the center fascia garnish
(A).
|
3. |
Disconnect 3 connectors (A) (A/C switch, Hazard switch and defroster
switch).
|
4. |
After loosening the mounting screws, then remove the audio assembly
(A).
|
5. |
Disconnect the audio connectors and cable (A).
|
Projected Dimensions ( 4 Door )
Front side member tooling hole (Ø6.6)
Side cover mounting hole
(B/B’: Ø6.6/ Ø8.6)
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is fo ...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil
...