Hyundai Accent: Removal
| 1. |
Loosen the windshield wiper arm nut (A) after removing a wiper
cap (B).
|
| 2. |
Remove the windshield wiper arm and blade.
|
| 3. |
If necessary, release the wiper blade fixing clip by pulling up
and remove the wiper blade from the inside radius of wiper arm.
|
| 4. |
Disconnect the washer hose (A) connected to cowl top cover.
|
| 5. |
Remove the weather strip and the cowl top cover (A) after removing
rivets.
|
| 6. |
Disconnect the wiper motor connector (A) from the wiper motor
& linkage assembly.
|
| 7. |
Remove the windshield wiper motor and linkage assembly (A) after
removing 2 bolts.
|
| 8. |
Hold the wiper motor crank arm and remove the upper linkage (A)
from the wiper motor crank arm.
|
| 9. |
Loosen 3 bolts and remove the wiper motor(A) from the wiper motor
crank arm.
|
Installation
1.
Install the wiper motor.
2.
Install the crank arm.
3.
Install the lower and upper linkage to the wiper motor ...
See also:
Anchor Pretensioner (APT). Description and Operation
Description
Front anchor pretensioner operates as well as Belt Pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on driver se ...
Passive Occupant Detection System (PODS-F). Description and Operation
Description
In order to make normal activation of airbag system, SRSCM detects DTC(s)
for the Passive occupant detection system (PODS-F). If the seat is occupied,
PODS-F detects passenger pr ...
Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Hyundai Accent Manuals
