Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Clutch System / Clutch System / Clutch Master Cylinder. Repair procedures / Removal

•	Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

1.	Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer.

2.

Remove the clutch pedal mounting nuts (A-2ea).

Tightening torque:

12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

3.	Remove the battery and ECM. (Refer to "Manual transaxle system" in MT group)

4.	Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.

5.	Remove the clutch master cylinder by turning it clockwise (A).

Clutch Master Cylinder. Repair procedures

...

Installation

1. Installation is the reverse of removal. • ...

See also:

All season tires
HYUNDAI specifies all season tires on some models to provide good performance for use all year round, including snowy and icy road conditions. All season tires are identified by ALL SEASON and/or ...

Inspection
1. Check the bushing for wear and deterioration. 2. Check the lower arm for deformation. 3. Check the all bolts ...

Check spark plugs and ignition system
Inspect your spark plugs as described in section 7 and replace them if necessary. Also check all ignition wiring and components to be sure they are not cracked, worn or damaged in any way. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com