Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Clutch System / Clutch System / Clutch Release Cylinder. Repair procedures / Removal

1.	Drain the brake fluid through the bleed plug (A).

2.

Remove the clutch release cylinder assembly (C) after removing thd tube (B) and nuts (A-2ea).

Tightening torque:

14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.9 ~ 15.9 lb-ft)

Clutch Release Cylinder. Repair procedures

...

Installation

1. Installation is the reverse of removal. Coat the clutch clevis push ro ...

See also:

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV termi ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia garnish (A). ...

Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be he ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com