Hyundai Accent Manuals

Hyundai Accent: Removal - Valve Body. Repair procedures - Hydraulic System - Automatic Transaxle SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Hydraulic System / Valve Body. Repair procedures / Removal

1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

3.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)" in this group)
4.
Remove the valve body cover (B).
Tightening torque:
13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)

5.
Remove thd air breather hose (A).
6.
Remove the plate and the detent spring (A) after removing the bolt.
Tightening torque:
11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)

7.
Remove the bolt (3ea) after disconnecting the solenoid valve (B) connector and the oil temperature sensor connector (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

8.
Remove the valve body assembly (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Valve Body. Repair procedures
...

Installation
1. Installation is the reverse of removal. • ...

See also:

Repair procedures
On-vehicle Inpection • Check that the battery cables are connected to the correct terminals. ...

Circuit Diagram (2)
...

Inhibitor Switch. Description and Operation
Description Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com