Hyundai Accent: Removal
| 1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 2. |
Turn the steering wheel so that the front wheels can face straight
ahead.
|
| 3. |
Remove the driver airbag module mounting bolts (2EA).
|
| 4. |
Remove the wiring fixing clip (C), and then release the connector
locking pin to disconnect the driver airbag module connector (B).
|
| 5. |
Remove the steering wheel and steering wheel column shroud. (Refer
to the Steering System group - "Steering Column and Shaft")
|
| 6. |
Disconnect the clock spring connector, then remove the clock spring.
|
Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
See also:
Sunglass holder
To open the sunglass holder, press the cover and the holder will slowly open.
Place your sunglasses in the compartment door with the lenses facing out. Push to
close.
WARNING
Do not keep ob ...
Starting the engine
WARNING
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, slippers, ski boots, etc.) may interfere with your ability to use the
brake, accelerator pedal, a ...
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wipe ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com