Hyundai Accent: Repair procedures

Components Operations

PCM (Power Train Control Module) 1. The PCM (ECM) (A) carries out a check of the ignition key using a special encryption algorithm, which is programmed into the transp ...

Teaching Procedures

1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM (ECM) or when providing additional keys to the vehicle owner. Th ...

See also:

PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly) 1. Ignition “OFF” ...

Inspection
Speed Operation Check 1. Remove the connector (A) from the wiper motor. 1. - 2. IGN+ 3. Parking 4. High 5. GND ...

Installation
Side Impact Sensor • Do not turn the ignition switch ON and do not connect the battery c ...