Hyundai Accent Manuals

Hyundai Accent: Replacement - Trunk Lid. Repair procedures - Exterior - Body (Interior and Exterior)Hyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Body (Interior and Exterior) / Exterior / Trunk Lid. Repair procedures / Replacement

Trunk Lid Assembly Replacement
•
When removing and installing the trunk lid, an assistant is necessary.
•
Put on gloves to protect your hands.
1.
Detach the clips, then remove the trunk lid trim (A).
2.
Disconnect wiring (B) and connectors.
3.
After loosening the mounting bolts, then remove the trunk lid (A).
Tightening torque :
6.9 ~ 8.8 N.m (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb-ft)

4.
Installation is the reverse of removal.
•
Replace any damaged clips.
Trunk Lid Latch Replacement
1.
Remove the trunk lid trim.
2.
Disconnect the trunk lid latch connector (A).
3.
Disconnect the cable (B), then loosen the latch assembly (C) mounting bolts and remove.
Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.
Installation is the reverse of removal.
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
Trunk Lid Weatherstrip Replacement
1.
Remove the trunk lid weatherstrip (A).
•
Do not apply sealant to the body.

2.
Installation is the reverse of removal.
•
Install the weatherstrip aligned with canter line (B).

Trunk Lid. Repair procedures
...

Adjustment
1. After loosening the trunk lid hinge (A) mounting bolts, adjust the trunk lid by moving it up or down, or right or left. 2. Adjust the tr ...

See also:

Installation
• Install the component with the specified torques. • ...

Inspection
Sprockets, Hydraulic Tensioner, Chain Guide, Tensioner Arm 1. Check the CVVT sprocket, crankshaft sprocket teeth for abnormal wear, cracks or damage. Repla ...

Cylinder Block. Components and Components Location
Components 1. Cylinder block 2. Ladder frame 3. Crankshaft 4. Crankshaft upper bearing 5. Crankshaft lower bearing 6. Thrust bearing 7. Main bearing cap ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com