Hyundai Accent: Rubber Parts And Tubes

Always prevent gasoline or from touching rubber parts or tubing.

Electrical System

1. Be sure to disconnect the battery cable from the negative (-) terminal of the battery. 2. Never pull on the wires when disconnecting con ...

Measuring Body Dimensions

1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there ...

See also:

Front Wheel Alignment
When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always positio ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Installation
1. Remove ignition key from the vehicle. 2. Disconnect the negative (-) cable from battery and wait for at least three minutes. ...