Hyundai Accent: SRS Control Module (SRSCM). Description and
Operation
Description
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between an event that warrants restraint system deployment
and an event that does not. The SRSCM must decide whether to deploy the restraint
system or not. After determining that pretensioners and/or airbag deployment
is required, the SRSCM must supply sufficient power to the pretensioners and
airbag igniters to initiate deployment.
The SRSCM determines that an impact may require deployment of the pretensioners
and airbags from data obtained from impact sensors and other components in conjunction
with a safing function.
The SRSCM will not be ready to detect a crash or to activate the restraint
system devices until the signals in the SRSCM circuitry stabilize.
It is possible that the SRSCM could activate the safety restraint devices
in approximately 3 seconds but is guaranteed to fully function after prove-out
is completed.
The SRSCM must perform a diagnostic routine and light a system readiness
indicator at key-on. The system must perform a continuous diagnostic routine
and provide fault annunciation through a warning lamp indicator in the event
of fault detection. A serial diagnostic communication interface will be used
to facilitate servicing of the restraint control system.
See also:
Replacement
[Disc Type]
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and ...
High mounted stop light bulb replacement
4 Door
1. Open the trunk lid.
2. Remove the socket by turning it counterclockwise.
3. Replace the bulb from the socket.
4. Install the socket by turning it clockwise.
5 Door
If the light is ...
Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the brake disc for scoring and damage.
3.
C ...