Replacement
1. |
Disconnect the battery negative cable from the battery.
|
2. |
Remove faulty part and fit bracket assembly to new part.
|
3. |
Secure new part to vehicle and fit connector.
|
4. |
Re-connect battery and turn ignition on.
|
5. |
Check that DTC flash rate matches virgin state indication.
|
Inspection
1.
Disconnect the back up lamp switch connector (A).
2.
Check the continuity between no. 1 and 2 terminals of backup lamp
switch. W ...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
Map lamp
Push the lens (1) to turn the map lamp on or off. This light produces a spot
beam for convenient use as a map lamp at night or as a personal lamp for the driver
and the front passenger.
DOOR ...