Hyundai Accent: Side Impact Sensor (SIS). Description and Operation

Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH).

Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.

Side Impact Sensor is also called A-SIS because it detects acceleration.

SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when the collision occurred.

Installation

• Do not turn the ignition switch ON and do not contact the battery cable while replacing the ...

Side Impact Sensor (SIS). Components and Components Location

Components ...

See also:

Measuring Body Dimensions
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there ...

Inspection
Armature 1. Remove the starter. 2. Disassemble the starter as shown at the beginning of this procedure. 3 ...

Front Disc Brake. Components and Components Location
Components 1. Guide rod bolt 2. Bleed screw 3. Caliper body 4. Caliper carrier 5. Inner pad shim 6. Brake pad 7. Pad retainer ...