Hyundai Accent Manuals

Hyundai Accent: Installation - Side Impact Sensor (SIS). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Side Impact Sensor (SIS). Repair procedures / Installation

Pressure Side Impact Sensor
1.
Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A).
Tightening torque :
1.1 ~ 1.3 N.m (0.11 ~ 0.13 kgf.m, 0.81 ~ 0.96 lb-ft)

•
Use the specified screws only.
2.
Install the front door trim.
(Refer to the Body group - "Front door")
3.
Reconnect the battery negative cable.
4.
After installing the pressure side impact sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
•
You must comply with the specified tightening torques with the tool specified because Pressure – Side Impact Sensors (P-SIS) may be broken or POP-NUT may be rotated.
•
Problems may be occurred in the durability of P-SIS or impact sensing performance may be depreciated if POP-NUT is rotated.
•
The door module must not be transformed because SRSCM judges a impact through the pressure sensor in the door module.
Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1.
Install the new side impact sensor with the bolt (B) then connect the side impact sensor connector (A).
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)

2.
Install the center pillar trim.
(Refer to the Body group - "Interior tirm")
3.
Install the door scuff trim.
(Refer to the Body group - "Interior tirm")
4.
Insert the seat belt to the anchor pretensioner (A).

Make sure the lock pin is connected properly.
5.
Reconnect the battery negative cable.
6.
After installing the Side Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
Pressure Side Impact Sensor • Removal of the airbag must be performed according to the ...

Seat Belt Buckle Switch (BS). Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status ...

See also:

Removal and Installation
1. Disconnect the battery negative terminal first, then the positive terminal. Tightening torque (-) terminal : 4.0 ~ 6. ...

Manual windows
To raise or lower the window, turn the window regulator handle clockwise or counterclockwise. WARNING When opening or closing the windows, make sure your passenger's arms, hands and body ar ...

Filter inspection
The climate control air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a long period, it sh ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com