Hyundai Accent Manuals

Hyundai Accent: Installation - Passive Occupant Detection System (PODS-F). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Passive Occupant Detection System (PODS-F). Repair procedures / Installation

PODS-F ECU
1.
Install the PODS-F ECU equipped seat track assembly.
(Refer to the Body group - "Seat")
2.
Install the seat cushion cover assembly.
(Refer to the Body group - "Seat")
3.
Install the front passenger seat assembly.
(Refer to the Body group - "Seat")
4.
Reconnect the battery negative cable.
5.
After installing the PODS-F, confirm proper system operation :
A.
Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
B.
Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the PODS-F does not require suppression and the passenger airbag is enabled.
Be sure to perform PODS-F reset with GDS after replcacing PODS-F equipped seat cushion.
PODS-F Mat
1.
Install the PODS-F Mat equipped seat cushion assembly.
(Refer to the Body group - "Seat")
2.
Install the front passenger seat assembly.
(Refer to the Body group - "Seat")
3.
Reconnect the battery negative cable.
4.
After installing the PODS-F, confirm proper system operation :
A.
Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
B.
Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the PODS-F does not require suppression and the passenger airbag is enabled.
Be sure to perform PODS-F zeroing with GDS after replcacing PODS-F equipped seat cushion.

Removal
PODS-F ECU 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front pa ...

PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly) 1. Ignition “OFF” ...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS). Schematic Diagrams
Circuit Diagram ...

Power Out Side Mirror Switch. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front d ...

Front Bumper. Components and Components Location
Components 1. Front bumper cover 2. Radiator grill upper cover 3. Front bumper side bracket [ LH] 4. Front bumper side bracket [RH] ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com