Hyundai Accent: Inspection
| Driver Airbag (DAB) |
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental airbag deployment will
result in serious personal injury.
|
| 1. |
Check pad cover for dents, cracks or deformities.
|
| 2. |
Check the airbag module for denting, cracking or deformation.
|
| 3. |
Check hooks and connectors for damage, terminals for deformities,
and harness for binds.
|
| 4. |
Check airbag inflator case for dents, cracks or deformities.
|
| 5. |
Install the airbag module to the steering wheel to check for fit
or alignment with the wheel.
|
Clock Spring
| 1. |
If, as a result of the following checks, even one abnormal point
is discovered, replace the clock spring with a new one.
|
| 2. |
Check connectors and protective tube for damage, and terminals
for deformities.
|
Removal
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Turn the steering wheel so that the ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for
at least three minutes befo ...
See also:
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Line Pressure Control Solenoid Valve. Description and Operation
Description
line pressure control solenoid valve is attached to the valve body. This
variable force solenoid valve directly controls the hydraulic pressure inside
the line pressure.
...
Parking Brake Assembly. Components and
Components Location
Components
1. Parking brake lever
2. Adjuster cable
3. Equalizer assembly
4. Parking brake cable
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com