Hyundai Accent Manuals

Hyundai Accent: Installation - Driver Airbag (DAB) Module and Clock 
Spring. Repair procedures - Airbag Module - Restraint (Advanced)Hyundai Accent: Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
3.
Connect the clock spring harness connector to the clock spring.
4.
Install the steering column shroud.
5.
Set the center position by setting the marks between the clock spring and the cover into line. Make an array the mark (▶◀) by turning the clock spring clockwise to the stop and then 2.0 revolutions counterclockwise.

6.
Install the steering wheel.
(Refer to the Steering System group - "Steering Column and Shaft")
7.
Connect the driver airbag (DAB) module connector, and then install the driver airbag (DAB) module on the steering wheel.
8.
Secure driver airbag (DAB) with the new mounting bolts.

Tightening torque:
7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)

9.
Connect the battery negative cable.
10.
After installing the airbag, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
B.
Make sure horn button works.

Inspection
Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one. ...

Passenger Airbag (PAB) Module. Description and Operation
Description The passenger airbag (PAB) is installed inside the crash pad and protects the front passenger in the event of a frontal crash. The SRSCM determines if and when to deploy the PAB. ...

See also:

Body Side Moldings. Repair procedures
Replacement Trunk Lid Garnish Replacement [Sedan] • When prying with a flat-tip ...

If you have a flat tire (with tire mobility kit)
For safe operation, carefully read and follow the instructions in this manual before use. (1) Compressor (2) Sealant bottle The Tire Mobility Kit is a temporary fix to the tire and the tire sho ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the trunk trim. (Refer to the BD group - " Trunk Lid") ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com