Hyundai Accent: Installation
Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
|
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes.
|
| 3. |
Install the new seat back assembly.
(Refer to the Body group - "Seat")
|
| 4. |
Install the front seat assembly.
(Refer to the Body group - "Seat")
|
| 5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfering with other parts.
|
| 6. |
Reconnect the battery negative cable.
|
| 7. |
After installing the side airbag (SAB), confirm proper system
operation:
|
Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
...
Curtain Airbag (CAB) Module. Description
and Operation
Description
Curtain airbags are installed inside the headliner (LH and RH) and protect
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of curtain ...
See also:
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil
...
Installation
1.
Install the power window switch module.
2.
Install the door trim panel after reconnecting the relevant connectors
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com