Hyundai Accent Manuals

Hyundai Accent: Removal - Master Cylinder. Repair procedures - Brake System - Brake SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Master Cylinder. Repair procedures / Removal

1.
Turn ignition switch OFF.
2.
Disconnect the brake fluid level switch connector (A) from the reservoir.
3.
Remove the brake fluid from the master cylinder reservoir with a syringe.
•
Be sure to completely remove foreign substances from around brake fluid reservoir and cap before opening the reservoir cap. If not, it may cause contamination of brake fluid and deterioration in braking performance.
•
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
4.
Disconnect the brake tube from the master cylinder by loosening the tube flare nut (A).
Tightening torque:
18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

5.
Remove the clutch hose (B). [MT Only]
6.
Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (C).
Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)


Master Cylinder. Repair procedures
...

Installation
1. Installation is the reverse of removal. 2. After installation, bleed the brake system. (Refer to Brake system bleeding) ...

See also:

Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

Components and Components Location
Components Location [Vehicle Components] 1. Automatic transaxle 2. Transaxle control module (TCM) 3. Shift lever 4. (DLC) [Transaxle Components ...

Child restraint system
Children riding in the car should sit in the rear seat and must always be properly restrained to minimize the risk of injury in an accident, sudden stop or sudden maneuver. According to accident s ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com