Hyundai Accent: Installation
| 1. |
Installation is the reverse of removal.
|
| 2. |
Use a SST (09581-11000) when installing the brake caliper assembly.
|
| 3. |
After installation, bleed the brake system. (Refer to Brake system
bleeding)
|
Inspection
Front Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Rear Disc Brake. Components and Components Location
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Brake pad
6. Pad retainer
...
See also:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk lower trim.
(Refer to the BD group - " Trunk Lid")
...
Wheel nut tightening torque
Steel wheel & aluminum alloy wheel:
65~79 lb·ft (9~11 kg·m)
If you have a tire gauge, remove the valve cap and check the air pressure. If
the pressure is lower than recommended, drive slowly ...
Fuel Pressure Control Valve. Repair procedures
Inspection
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the fuel pressure regulator valve ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com