Hyundai Accent Manuals

Hyundai Accent: Replacement - Rear Disc Brake. Repair procedures - Brake System - Brake SystemHyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Rear Disc Brake. Repair procedures / Replacement

Rear Brake Pads
1.
Loosen the guide rod bolt (B) and then remove the rear caliper body (A).
Tightening torque:
21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~23.1 lb-ft)

•
Where necessary prevent the guide rods from rotating with an appropriate wrench.
•
Be careful not to damage the dust covers.
2.
Replace pad retainers (A) and brake pads (B) in the caliper carrier (C).

•
Clean the pad retainer surface at the caliper bracket.
•
Inspect the piston boots for damage and replace if necessary.
•
Check the smooth action of the guide rods, and their dust covers for damage.

Removal
1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Inspection
Rear Brake Disc Thickness Check 1. Check the brake pads for wear and fade. 2. Check the brake disc for damage and cracks. ...

See also:

Check battery and cables
Winter puts additional burdens on the battery system. Visually inspect the battery and cables as described in section 7. The level of charge in your battery can be checked by an authorized HYUNDAI ...

Inspection
1. Disconnect the ignition switch connector (B) and key switch connector (A) from under the steering column. 2. Check for continui ...

SS-A Solenoid Valve(ON/OFF). Description and Operation
Description SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com