Hyundai Accent: Parking Brake Adjustment
|
| 1. |
Remove the floor console to reach the adjusting nut.
|
| 2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
| 3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
| 4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) and (D) between operating lever (B) and stopper (C).
|
| 5. |
Refit the floor console.
|
| 6. |
Parking brake lever in the car must be in fully loosened position.
|
| 7. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
| 8. |
Check the wheels of their free operation.
|
| 9. |
Test drive.
|
Installation
Rear Drum Brake. Components and Components LocationUsing the Tire Mobility Kit
1. Detach the speed restriction label (0) from the sealant bottle (1), and place
it in a highly visible place inside the vehicle such as on the steering wheel to
remind the driver not to drive too ...
Refrigerant label
The refrigerant label is located on the underside of the hood. ...
Filter replacement
1. Open the glove box and remove the support strap (1).
2. With the glove box open, remove the stoppers by turning them counterclockwise
on both sides.
3. Remove the climate control air filt ...