Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Rear Drum Brake. Repair procedures / Removal

•	Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.

•	Avoid breathing dust particles.

•	Never use an air hose or brush to clean brake assemblies.

1.	Release the parking brake.

2.

Remove the rear wheel & tire.

Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

3.	Remove the rear brake drum (A).

4.	Remove the upper return spring (A).

5.	Remove the lower return spring (B).

6.	Remove the shoe hold springs (A) and shoe hold pins (B) and then remove brake shoe (C). Make sure not to damage the dust cover on the wheel cylinder.

7.	Remove the parking brake cable (A) and then remove brake shoe (B).

8.	Disconnect brake tubes (A) from the wheel cylinder (B).

9.	Remove the bolt (C) and the wheel cylinder (B) from the backing plate (D).

Rear Drum Brake. Repair procedures

...

Installation

• Do not spill brake fluid on the vehicle: it may damage the paint; if brake fluid does conta ...

See also:

Overhead Console Lamp. Schematic Diagrams
Circuit Diagram ...

Maintenance under severe usage conditions
The following items must be serviced more frequently on cars normally used under severe driving conditions. Refer to the chart below for the appropriate maintenance intervals. R : Replace I : I ...

Installation
1. Installation is the reverse of removal. 2. Use a SST (09581-11000) when installing the brake caliper assembly. 3 ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com